Asset details
A complete in-bay rollover car wash building whose machine works: the gantry runs the bay, the top brush follows the roof, the side brushes close round the car, the roll-up doors open, and a tyre conveyor pulls the car in and out. 14 clips, 15 working lights, effect sockets for water, foam and dryers.
A game-ready in-bay rollover car wash: an 18 x 37 ft split-face block bay with a blue ribbed fascia and lit CAR WASH and THANK YOU signs, a framed polycarbonate clerestory, white PVC liner panels inside, roll-up doors with rolled coil hoods and operators at both ends, a pay station on its island, door bollards, wall packs and an equipment room with a working steel door.
The wash machine is a stainless gantry on floor rails: flanged-wheel trucks with drive motors, a top brush that lifts to follow the car's roof, two side brushes that close across the bumpers and ride the car's sides, a spray arch, a foam arch with a lit header, and roof dryer blowers with flex ducts down to the leg dryers. A tyre conveyor runs down the driver-side wheel line: its roller rises behind the front tyre and pulls the car to the wash position, then on out of the exit.
Inside the equipment room: the wash's control cabinet with a lit screen and pilot lights, the high-pressure pump skid, chemical drums on a spill pallet and a fire extinguisher.
Clips (14): WashCycle (the full 57-second programme: pre-soak, brush pass round the car, rinse, dry), BrushSpin (loop), PassForward, BrushPass and PassReturn (chain them into your own wash packages), EntryDoorOpen/Close, ExitDoorOpen/Close, RoomDoorOpen/Close, ConveyorPullIn, ConveyorPullOut and ConveyorReturn.
Game hooks: every moving part is its own bone (gantry, top brush lift and spin, both side brushes, both door curtains, the conveyor roller and its lift, the room door), so you can drive them from your own wash controller. Sockets mark the seven spray, foam and dryer emitters for your particle effects, where the car stops, the entry and exit, and the conveyor roller's push point for attaching a car's wheel. 15 working lights (bay, outside, room, beacon, foam header and each signal lamp) are listed with their positions, brightness and colour in switchable banks.
The car shown in the images is not included.
Includes FBX (skeletal mesh plus one FBX per clip), a GLB with every clip embedded, and baked colour, normal and roughness maps. Unreal Engine 5.5, 5.6 and 5.8 projects with a drop-in Blueprint and an overview map.
Unreal Engine: the download includes a ready-to-open Unreal project for UE 5.5, 5.6 and 5.8, the same projects Fab buyers get, with the meshes, materials, Blueprints and a demo map set up, alongside the FBX and GLB.